We would like to inform you that a new version of the ScopeDome Arduino card driver is available.
The most important two new features are:
– new firmware version (ver. 6.7),
– rebuilt Bad Weather sensor system.
The firmware has been recompiled with new modules for IP support. It is much more stable than previous versions. It’s really worth installing it in your card.
The Bad Weather sensor has become configurable. Configuration options allow you to select many new weather conditions, such as: too high humidity, too low temperature, day/night. We have also improved cooperation with the popular AAG CloudSensor. It is now possible to read the relay status and Unsafe status transmitted by the sensor cloud log independently.
More information can be found in the Driver Manual on page 34.
Good morning.
I am going to connect to a 2m dome later this week.
I only need to install the ScopeDome Arduino card driver, correct?
I do not need to install the ScopeDomeUSBDomeDriver ver 5.1.40., correct?
Thank you and have a great week.
JY
Hello,
Thank you for the above clarification.
My scopedome 2m is installed, working with intermittent faults and software not responding.
I have a basic question, sorry if it is obvious but I really would appreciate if you could clarify:
I am connecting the dome/arduino card through ethernet.
Can I unplug the USB cable? I have a feeling it is creating some interference …
Thank you and have a great week end
JY
