– Connect the card to your computer via a USB connection.
– Open ScopeDome driver and conect it to the card via USB.
– Connect your computer and the card to the same IP network hub.
– Launch Command Prompt and enter the command “ipconfig”.
– Read the „IPV4 Address” value (in this example: 192.168.2.198).
– This means that your computer is operating on the 192.168.2.x network.
– Select a free IP address on your network, e.g., 192.168.2.120.
– Enter this address in the “IP address” field in the card’s Config window and press the “Set IP” button.
– Press „Save Settings” button
– Restart card power
– Set „Connect by” value to „Ethernet”
– Press „Save Settings” button
– Close config window and restart the driver.
P.S.
Remember that the card’s IP address can only be changed when it is connected to a computer via a USB port.
