https://forum.scopedome.com/community/main-category-2-scopedome-driver/ardruino-driver-and-home-made-dome/ wordpressplugins Discussion Board pl-PL Mon, 17 Aug 2026 14:23:27 +0000 wpForo 60 https://forum.scopedome.com/community/main-category-2-scopedome-driver/ardruino-driver-and-home-made-dome/#post-322 Wed, 17 Jun 2026 10:00:18 +0000 Please read this manual:

124]]> SCOPEDOME Arduino driver admin https://forum.scopedome.com/community/main-category-2-scopedome-driver/ardruino-driver-and-home-made-dome/#post-322 https://forum.scopedome.com/community/main-category-2-scopedome-driver/ardruino-driver-and-home-made-dome/#post-321 Sun, 14 Jun 2026 15:40:27 +0000 I have the following configuration: home made dome with a diameter of 3.02m, Arduino driver from Scopdome, Ioptron cem 120 mount, Askar 185 telescope... from the zero position of the dome it moves in any direction with an accuracy of + or - 3 minutes... the problem occurs when synchronizing with the telescope: if I enter the measured geometric data and do not enter the GEM value = 0 (the measured one is 361mm) the dome moves from position 0 around 22° also even if in position 0 it is centered on the shutter (width is 700mmm) the telescope stops at the edge of the shutter with small differences depending on the x and y values ​​entered... it is probably a geometry problem but I can't figure out where I am wrong. Does anyone have an idea that could help me?

]]> SCOPEDOME Arduino driver dorin.ivan https://forum.scopedome.com/community/main-category-2-scopedome-driver/ardruino-driver-and-home-made-dome/#post-321